| |
 |
| |
Machining Between Walls
One of the most important advantages of the CUT-GRIP and TOP-GRIP systems is the ability to machine between walls.To achieve the best results,the following sequence is recommended:
Roughing
Plunge to depth of cut.Pull back 0.2mm radially.Turn longitudinally, retract at the end of the cut by 0.2 mm simultaneously in radial and axial directions.Plunge again and repeat same cycle leaving steps
of 0.2 mm at the shoulders for the finishing cut.
Minimum DOC has
to be ap≥R (corner radius).
Finishing
Plunge on the right side r eaching the tangent of bottom radius.
Retract and relieve the tangent point of the other side radius.
Retract and machine all the contour,pulling back by compensation
value along the bottom (See pages B151-152).
|
|